RSMA181 Chief

Petunjuk RSMA181 Chief

(1)
  • INSTALLATION INSTRUCTIONS
    Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
    no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
    of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
    implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
    Chief Manufacturing, a products division of Milestone AV Technologies
    8401 Eagle Creek Parkway, Savage, MN 55378
    • P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
    8802-000248 Rev01
    ©2009 Milestone AV Technologies,
    a Duchossois Group Company
    05/09
    SSB-181, SSM-181, SLB-181 and SLM-181 Interface Brackets
    SSB-181, SSM-181, SLB-181 and SLM-181 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
    installation instructions provided with the mount for additional installation information.
    Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
    WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
    Installation Instructions
    WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
    DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
    NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
    1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
    2. Turn projector upside down on a flat surface.
    3. Place the .500" nylon spacers over the threaded inserts in the bottom of the projector
    4. Place the interface bracket onto nylon spacers in the bottom of the projector and align the holes in the bracket with the threaded inserts in
    the bottom of the projector.
    5. Using the M4 x 20mm mounting screws, position mounting screws into the mounting holes. Tighten all fasteners at this time, securing the
    bracket to the projector.
    NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation instructions
    in the All-Points Security Kit.
    Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
    (1) Interface Bracket (2) Screw, Phillips Flat Head, M4 x 20mm
    (6) 10-24 Thumb Nuts ** (2) Screw, Phillips Pan Head, M4 x 20mm
    (1) All-Points Security Kit (2) Washers, Flat, M4
    (4) Spacer, Nylon, .500 x .194 x .500
    **Only used when installing SLB/SSB interface brackets.
    NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
    encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
    interface bracket installation.
    SLB-181 SLM-181
    (
    N
    o
    t
    e
    :
    S
    S
    -
    s
    t
    y
    l
    e
    i
    n
    t
    e
    r
    f
    a
    c
    e
    b
    r
    a
    c
    k
    e
    t
    c
    o
    n
    n
    e
    c
    t
    i
    o
    n
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
    (
    Note:
    SSB-
    style
    inter
    face
    b
    r
    a
    c
    k
    e
    t
    c
    o
    n
    n
    e
    c
    t
    i
    o
    n
    s
    a
    r
    e
    e
    n
    c
    i
    r
    c
    l
    e
    d
    )
    Towards front of
    projector
    Towards front of
    projector
RSMA181 Chief

Apakah Anda memiliki pertanyaan tentang RSMA181 Chief?

Jumlah pertanyaan: 0

Ajukan pertanyaan anda mengenai Chief RSMA181 di sini kepada pemilik produk lainnya. Sampaikan dekripsi yang jelas dan singkat tentang masalah dan pertanyaan anda. Semakin jelas penjelasan masalahnya, semakin mudah bagi pemilik Chief RSMA181 lainnya untuk menyediakan jawaban terbaik.

Tampilkan panduan gratisChief RSMA181 di sini. Anda sudah membaca panduan tetapi tidak menjawab pertanyaan anda? Silakan ajukan pertanyaan anda pada halaman ini kepada pemilik Chief RSMA181 lainnya. Ajukan pertanyaan Anda di sini

spesifikasi produk

Umum
Brand Chief
Model RSMA181
Produk Penyangga panel datar
EAN 841872132143
Bahasa Inggris
Jenis berkas PDF
Performa
Jenis dudukan ceiling
Berat maksimal (kapasitas) -kg
Warna produk Hitam

petunjuk.co.id

Mencari panduan? petunjuk.co.id menjamin anda untuk menemukan panduan yang anda cari dalam waktu singkat. Database kami memuat lebih dari 1 juta panduan PDF untuk lebih dari 10,000 merek. Setiap hari kami menambahkan panduan terbaru sehingga anda akan selalu menemukan produk yang anda cari. Sangat mudah: hanya dengan mengetikkan nama merek dan tipe produk dalam kotak penelusuran dan anda akan melihat secara instan panduan yang anda pilih secara online dengan gratis.

petunjuk.co.id

© Hak Cipta 2020 petunjuk.co.id. Hak Cipta Dilindungi.