WLX20220IT Bosch

Petunjuk WLX20220IT Bosch

(1)
  • 1
    Safety instructions
    The washing machine is heavy – take care when lifting it.
    Warning: Frozen hoses may tear/burst. Do not install the washing machine outdoors and/
    or in areas where there is a risk of frost.
    The washing machine may be damaged. Do not lift the machine by any of its projecting
    parts (e.g. the washing machine door).
    In addition to the instructions mentioned here, special regulations regarding the relevant
    water and power supply companies may apply.
    If in doubt, have the appliance connected by a technician.
    Lay hoses and cables in such a way that there is no risk of tripping.
    Environmentally-friendly disposal
    Dispose of packaging in an environmentally friendly manner.
    This appliance has been identified in accordance with the European Directive 2012/19/EU
    on Waste Electrical and Electronic Equipment (WEEE). This directive specifies a framework
    for the return and recycling of waste appliances, and is valid throughout Europe.
    Installation area
    It is important to ensure that the machine is stable to prevent it from "wandering"!
    The installation area must be firm and level.
    Soft floors/floor coverings, e.g. carpets, are not suitable.
    Keep the surrounding area dry and well-vented.
    If installing the appliance on a stand
    It is essential to secure the washing machine feet using holding brackets*.
    If installing the appliance on a wooden joist floor
    If possible, install the washing machine in a corner.
    Screw a water-resistant wooden panel (min. 30 mm thick) to the floor.
    It is essential to secure the washing machine feet using holding brackets*.
    *The holding brackets can be obtained from a specialist store or from after-sales service.
    Built-under/built-in appliances
    Build these appliances under/in before connection to the power supply.
    Installed in between kitchen units (built-under or built-in)
    60 cm cavity width required.
    Install the washing machine only under a continuous worktop that is connected firmly to the
    adjacent cupboards.
    For safety reasons in built-under installation, a metal cover* must be assembled by a
    specialist in place of the appliance cover plate.
    *The metal cover can be obtained from a specialist store or from after-sales service.
    2
    Removing the packaging
    Please remove the bottom foam and also foam support
    from the bottom of appliance when you are removing the
    packaging!
    Standard accessories
    Water inlet hose.
    Water drainage hose.
    Elbow for attaching the water drainage hose e.g. to a wash basin.
    Power cord.
    Covers for holes left by removing the transport bolts.
    Depending on the connection
    A 24-40 mm dia. hose clip may also be required for connecting the siphon (available from
    specialist retailers). -> Page 4: Water connection
    Useful tools
    Spirit level for aligning the appliance.
    Spanner for adjusting the appliance feet.
    Hose and cable lengths
    For WM, WAX, WAE series
    For WS, WLX, WLG series
    Available from dealer/after-sales service:
    Extended water inlet hose, approx. 2.20 m
    m
    a
    x
    .
    1
    0
    0
    c
    m
    140cm
    ~
    ~
    100cm
    ~
    ~
    11
    0
    cm
    ~
    ~
    m
    a
    x
    .
    1
    0
    0
    c
    m
    150cm
    ~
    ~
    110cm
    ~
    ~
    1
    5
    0
    c
    m
    ~
    ~
    Connection on left side Connection on right side
    m
    a
    x
    .
    1
    0
    0
    c
    m
    145cm
    ~
    ~
    1
    0
    5
    cm
    ~
    ~
    100-130cm
    ~
    ~
    m
    a
    x
    .
    1
    0
    0
    c
    m
    90cm
    ~
    ~
    1
    5
    0
    c
    m
    ~
    ~
    150-180cm
    ~
    ~
    Connection on left side Connection on right side
    3
    Removing the transport bolts
    Before using the appliance for the first time, always remove and retain all 4 transport bolts
    from the back of appliance.
    Be careful when handling these to avoid injury.
    For WM, WAX, WAE series
    1. Use a spanner to loosen all fixing bolts (A) until
    they turn freely.
    2. Remove the four parts (B). They will fall to the floor
    when you tip the machine.
    3. Insert the covers (C), which you will find in the bag
    containing the documentation.
    For WS, WLX, WLG series
    1. Use a spanner to loosen the four bolts until they
    turn freely, and then remove them.
    2. Insert the covers, which you will find in the bag
    containing the documentation.
    D
    C
    4
    Water connection
    To prevent leaks or water damage, follow the instructions in this chapter.
    Note: Operate the washing machine with cold water only.
    Do not connect to a mixer tap of a unpressurised boiler.
    Do not remove the water inlet hose frequently as the loose connection will lead to leaks.
    We recommend that you use a water inlet hose that is specially made for the machine.
    Do not use a used inlet hose. Only use the inlet hose supplied or one that was purchased
    from an authorised specialist dealer.
    If in doubt, have the appliance connected by a technician.
    Water supply
    Water inlet hose:
    Note: Do not bend, crush, modify or cut through the hose (the strength is no longer
    guaranteed).
    Optimum water pressure in the mains: 100-1000 kPa (1-10 bar)
    When the tap is turned on, the water flow should be at least 8 l/min.
    If the water pressure is higher, install a pressure reducing valve.
    1. Connect the water inlet hose to the tap.
    Tighten the plastic screw-fittings by hand only.
    2. Carefully turn on the tap and check that the connection
    points are not leaking.
    Note: The screw connection is under water mains
    pressure.
    Water drainage
    Water drainage hose:
    Note: Do not bend or stretch the hose.
    Height difference between the installation area and outlet: max. 100 cm
    Drainage into a sink/bath tub:
    Note: Secure the drainage hose to prevent it from slipping out of
    the sink.
    Note: The plug must not be in the plug hole. When the water is being
    pumped out of the washing machine, check that the water drains away
    quickly enough. Do not insert the end of the drainage hose in the water that
    has been pumped out. There is a risk that water will be drawn back into the
    washing machine.
    Drainage into a siphon:
    Note: Secure the connection with a 24-40 mm dia. hose clip
    (available from a specialist retailer).
    min10mm
WLX20220IT Bosch

Apakah Anda memiliki pertanyaan tentang WLX20220IT Bosch?

Jumlah pertanyaan: 0

Ajukan pertanyaan anda mengenai Bosch WLX20220IT di sini kepada pemilik produk lainnya. Sampaikan dekripsi yang jelas dan singkat tentang masalah dan pertanyaan anda. Semakin jelas penjelasan masalahnya, semakin mudah bagi pemilik Bosch WLX20220IT lainnya untuk menyediakan jawaban terbaik.

Tampilkan panduan gratisBosch WLX20220IT di sini. Anda sudah membaca panduan tetapi tidak menjawab pertanyaan anda? Silakan ajukan pertanyaan anda pada halaman ini kepada pemilik Bosch WLX20220IT lainnya. Ajukan pertanyaan Anda di sini

spesifikasi produk

Umum
Brand Bosch
Model WLX20220IT
Produk Mesin Cuci
EAN 4242002695563
Bahasa Inggris
Jenis berkas PDF
Daya
Kelas efisiensi energi A+
Konsumsi energi per siklus mencuci 0.73kWj
Konsumsi air pencucian tahunan 8900
Konsumsi listrik pencucian tahunan 155kWj
Konsumsi daya (rata-rata) 2300W
Arus 10A
Tegangan masukan AC 220-240V
Frekuensi masukan AC 50Hz
Konsumsi daya (mati) 0.1W
Konsumsi air per siklus 51
Bersertifikat Energy Star
Desain
Layar terpasang
Jenis tampilan LED
Jenis pemuatan Muatan depan
Tipe Bebas berdiri
Panjang kabel 1.75m
Engsel pintu Kiri
Volume drum 35
Panjang selang masuk 1.5m
Panjang selang keluar 1.5m
Sertifikasi CE, VDE
Bahan drum Plastik
Tipe kontrol Buttons, Rotary
Warna produk Putih
Warna pintu Putih
Performa
Kelas pencucian A
Jumlah program pencucian -
Kapasitas drum 4.5kg
Kecepatan putaran maksimal 1000RPM
Kelas pengering di mesin cuci D
Waktu siklus (maks) 150men
Tingkat kebisingan (cuci) 58dB
Sistem penyeimbang muatan
Embun sisa 75
Tingkat kebisingan (putaran) 74dB
Kecepatan putaran dapat disesuaikan
Ergonomik
Kunci anak
Kaki dapat disesuaikan
Penyesuaian kaki 12mm
Indikator sisa waktu
- Blouse/shirt, Delicate/silk, Hand/wool, Pre-wash, Quick, Sport, Synthetics
Program mencuci
Setengah-beban
Program mencuci alergi
Program mencuci warna hitam
Program mencuci baju blus/kemeja
Program pencucian sutra/halus
Program pencucian tangan/wol
Program pra-cuci
Program pencucian cepat
Program pencucian olahraga
Program pencucian sintetis
Berat dan dimensi
Panjang 600mm
Lebar 400mm
Tinggi 850mm
Berat 62000g
Lebar dengan pintu terbuka 880mm
Data pemaketan
Panjang kemasan 664mm
Lebar kemasan 550mm
Tinggi kemasan 860mm
Berat kemasan 65000g

petunjuk.co.id

Mencari panduan? petunjuk.co.id menjamin anda untuk menemukan panduan yang anda cari dalam waktu singkat. Database kami memuat lebih dari 1 juta panduan PDF untuk lebih dari 10,000 merek. Setiap hari kami menambahkan panduan terbaru sehingga anda akan selalu menemukan produk yang anda cari. Sangat mudah: hanya dengan mengetikkan nama merek dan tipe produk dalam kotak penelusuran dan anda akan melihat secara instan panduan yang anda pilih secara online dengan gratis.

petunjuk.co.id

© Hak Cipta 2020 petunjuk.co.id. Hak Cipta Dilindungi.